Operation - Hatco CDW-3N Series Installation And Operating Manual

INSTALLATION
Installing Casters
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.

OPERATION

General
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
BURN hAzARD:
• Some exterior surfaces on the unit will get hot. Use
caution when touching these areas.
• Use caution when opening drawer. hot air escapes
when drawer is open.
CAUTION
Digital Temperature Controller
Caster Plate
Bolt
"out 1"
SET Down Arrow
Key
Key
NOTE: The digital temperature controller is pre-set to a setpoint
temperature of 91°C (195°F) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The maximum setpoint temperature is 91°C
(195°F).
POWER ON/OFF Switch
Mounting
Bracket
Celsius
Symbol
Up Arrow
Key