Rinnai Energysaver RHFE-1004FDT How To Use Manual page 19

Fix Flue Adapter t o Flue.
Manifold with Locking Clamp S as shown
below.
Air lnlet Hose
Connect Air lnlet Hose to Manifold Inlet.
Do not kink the hose.
Secure with plastic tie as-shown below.
Locking clamp S
7
d
,Fl u e Manifold
Flue Adapter
Fit Air inlet Hose t o heater.
Fix Side Back Spacers with screws
1. Connect the flue outlet to the manifold by
extending the stainless steel sliding tube
until it is fully inserted into the manifold.
I
Flue Manifold
I
Sliding Tube
\
Sliding Tube s h o u l d n o t be extended
beyond the RED LINE.
Place top back spacer i n position.
Mark the position of the top edge of the top 2. Fit the Locking Clamp L over connection
spacer on the wall. Move the heater away
from the wall. Mark centre lines 20mm down
from the top edge mark, and 12mm in front
the left and right hand sides of the top spacer.
Attach wall brackets at the marked Dosition.
Fit lnlet Elbow
Fit a suitable inlet fitting to R1 1 2 15mm
threaded fitting on the rear of the heater.
Normally, the most suitable fitting is an RC 1 1 2
15
X
15mm copper flare elbow.
The appliance can then be connected with
15mm copper tube.
between sliding tube and manifold.
Engage the hook and rotate it until it snaps
against the body of the clamp.
Flue outlet
- .
\
Hook
' . ,
Locking Locking
clamp
Clamp