Rinnai Energysaver RHFE-1004FDT How To Use Manual page 18

METHOD FOR STANDARD WALLS
1
5. Check rubber seal is in place on terminal.
I
For weather board walls, add spare rubber
seal provided to compensate for weather
board angle.
seal here)
6. Installation of Terminal
From outside, insert terminal into sleeve
with the " A mark at the top.
Left hand side fixing tie is marked "LEFT"
(from inside) .
7. Attaching Ties
Pull hard on left and right hand side ties.
clip ties over lugs inside sleeve.
You should be able to pull the ties 2 or 3
slots past the starting point.
Cut the ties. leaving about 20mm past the
lugs. Bend ties so they are parallel with the
wall.
8. Insert Inner Connection Assembly Push
assembly into terminal tube, make sure
"TOP mark is uppermost.
Fix with 3 screws ~rovided.
C u : (leave 20mm free)
9. Manifold can still be turned after attaching
Outlet
Rubber cap
. -