Display; Before You Carlforservice - GE GSD4410 Owner's Manual

Before you call for service...
Troubleshooting Tips
Review the charts on the following pages first and you may not
need to call for service.
Control panel lights go
off when you're settimj
controls
Possible Causes
Time too long between
touching of selected pads
What To Do
Each pad must be touched
_4thin 30 seconds of the
others. To relight, touch
aW pad again, or unlock
and relatch door.
The word AUTO doesn't
appear in the display
Dishwasher wont run
The sensor is dogged
or faulty
T1)-using the below stops
to clear the sensor:
1 Remove all melal
ulensils tiom the
dishwasher.
2 DO NOTADDDETERGENT.
3 Select POTSPANScycle
and ENERGY SAVER DRY
OFF.
4 Start the dishwasher and
allow to run until tim
time remaining in the
cycle appears in the
display.
5 Then open the door and
pour 1/4 cup ofcitliC
acid c_Tstals into the
bottwm of the
dishwasher. (Most
dpagstores can): citlic
acid c_7s/als. If yours
doesn't, call GE Se_qce
and Paris (]enters.)
6 (]lose the door and allow
the dishwasher to
complete the cycle.
If dm problem continues
call fbr sei_qce.
Fuse is blown, or the
circuit breaker tripped
Replace fllse or reset
circuit breaker. Remove
any other appliances flom
the circuit.
T1)- resetting the display
panel.
22