GE GSD4410 Owner's Manual page 14

About the display diagnostic codes.
What It Means What To Do
ill _ _i
%1 i ii
Not enough water is
entering the dishwasher.
OR
l Jnlatch tile door. If there is no water in
tile bottom of file dishwasher, check tile
wamr supply It) the dishwasher.
Is the dishwasher water supply mined on?
Is the household water supply turned on?
If you use well or cislenl water, is tile
supply adequate?
If tile water supply is adequam, tD" file
(Tcle again. If KS repeats, call for sei_ce.
Thetemporarily drain pump blocked could be
(usually caused by food
particles such as cereal).
IJnlatch the door. If there is slanding
waler in the bollom of tile dishwasher,
relatch tile door,
touch
START, then
immediately touch
RESETIo Stall tile
pmnp. If K5 continues
In
appear, you
may need 1/) do this several times to
break up tile blockage.
i i i
i ii ii i I i i i i !i !iii ili I i ii
The water temperature
in the dishwasher did not
reach the proper wash
temperature. This is
usually caused by lack of
hot water coming from the
household water heater.
Avoid showers or laundlT.just prior to
nmning tile dishwasher. (Use tile
DEtAgSYARYteamre to
start
dishwasher
when dm water heater is up to normal
temperature.) Adjust household
water healer thermostat to 120 °F.
minimum.
If E5 appears _dth eveD_cycle and you
know the water flom the water heater is
hot (120°F. or more), call fbr service.
W_ The temperature sensor
L. _ in the dishwasher is not
functioning properly.
Dishwasher may conlinue
to be used, but it will not
heat water automatically.
Tile lemperature sensor needs to be
replaced. Call fi)r service.
NOTE: Y ou In W continue
1/)use your
dishwasher. For best results a(!just your
household water heater thermostat
to 140 °F
74
Before You Ca/I For Service
TD_tile Cv(le again to see iftile (ode reappears. Tile dishwasher may
conect itself.
Elecuonic conu-ols can be aflecmd by ou/side inmrterence. Shutting off
power u) tile dishwasher (at tile fuse or circuit breaker) could correct
tile problem. Restore power after 15 seconds and tD-tile cycle again.
Check tile g_lide fbr things you can do u) correct tile problem.
See tile #oubleshootin.q Tips at tile back of this manual.