GE GSD4410 Owner's Manual page 25

Dishes don't dry
Dishes and flatware
not clean
Possible Causes
Low inlet water
temperature
Rinse agent dispenser
is empty
Inlet water temperature
is below 120°F.
What To Do
Make sure inlet water
temperature is correct.
Check the rinse agent
dispenser.
Raise tim water healer
temperature to 120°F.
Water pressure is
temporarily low
Air gap is clogged
Improper rack loading
Turn on a fhucet. Is water
coming out more slowly
than usual? If so, wait until
pressure is normal before
using your dishwasher.
Clean the air gap.
Make sure large dishware
does not block tim
detergent dispenser or the
wash ann.
Spots and filming
on glasses and
flatware
Extremely hard water
Low inlet water
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little detergent
To remove stubborn spots
from glassware:
1 Remove all melal
ulensils flom the
dishwasher.
2 Do not add demrgent.
3 Select the longest cycle.
4 Stmt the dishwasher and
allow to nm fi)r 18 u_ 22
minutes. Dishwasher xdll
now be in the main wash.
5 ()pen the door and pour
2 cups (500 ml) of while
_qnegar into the bottom of
the dishwasher.
6 Close the door and allow
lo complele tim cycle.
If vinegar rinse doesn't
_xnk: Repeat as above,
except use 1/4 cup (60 ml)
of citric acid custals
instead of vinegar.
iiii!ii_i!iHH
25