Verify Shipping Contents; Planning The Installation - Brivo ACS100 Installation Manual

Verify shipping contents.

1. Locate and check the contents of the Control Panel kit.
The ACS100 kit should contain the following parts:
a) 1 cardboard box containing the following:
·
·
·
·
·
·
Plan your installation. Decide where to install the ACS100.
1. If not using Power Over Ethernet (PoE), do not place the ACS100 more than 100 feet from the
transformer. This is the maximum cable run allowed by most external power supplies.
a) Calculate the distance between the ACS100 and its associated keypad or reader. The ACS100
does not specify a maximum distance between the ACS100 and a keypad or reader, but the
keypad/reader manufacturer does. Follow manufacturer guidelines for each keypad
and reader.
b) Place the ACS100 within 50 feet of its associated electronic strike or latch.
© 2020 Brivo Systems LLC. All rights reserved.
The ACS100 unit, with its identification label on the back
An additional loose label for reference.
A quick start guide
A bag of accessory parts containing:
· 1 MOV (Metal Oxide Varistor)
· 2 120 ohm RS-485 bus termination resistors.
Back mounting metal plate and attachment screw
Pigtail cable with connections for door I/O and optional external reader
7
P-MAN-PUB-Brivo ACS100 Installation Manual
Brivo ACS100 Installation Manual