ABB AC 900F Mounting And Installation Instructions Manual page 102

Controller configuration via terminal program
Auto restore
Auto restore from SD card [n]
The controller can be configured to automatically restore the configuration data
saved on the SD card (Backup config) when a cold start is initiated. For more
information on this function refer to
Diagnostic interface
Enter baudrate of console port: [19200]
The Diagnostic interface transmission rate can be set to 9600 Bit/s or 19200 Bit/s.
Default value is 19200 Bit/s.
Waiting time for the configuration block start-up
Enter CPU delay (in seconds) before starting up: [2]
Any value between 2 and 60 seconds can be entered for the waiting time. In case of
an invalid entry, the boot loader repeats this configuration item. It is recommended
not to change the default setting.
The boot loader then displays the current configuration data that are still to be saved.
The default setting for all other parameters must not be changed!
102
Section 8,
transmission rate
Section 7 Commissioning
Service.
M&I – AC 900F Controller