Advertisement
1
STEP
2
STEP
5
ORANGE BAG
1
STEP
• Insert one of the console supports
into the console support bracket and
secure with three bolts (M8x65L) in the
side of the console support bracket.
• Secure the rear of the console
support using bolt (M8x20L)
• Use the 5mm L-shaped Allen wrench
to tighten all bolts.
• Repeat this step on the opposite
side. NOTE: The right console support
has a white wire tie attached to it.
BLUE BAG
2
STEP
• Slide the data cables down the right
console support using the white wire
tie as a guide. Make sure that the
data cables come out the hole in the
side of the console support.
• Mount the console to the console
mast using the four flathead bolts
(M8x20L) and tighten with the blue
handled 5mm L-shaped Allen wrench.
NOTE: Push all extra data cable into
the console mast. Make sure not to
pinch or cut the data cable.
Advertisement
