Vision Fitness ST740 Owner's Manual page 12

AH1 AH1
AC1 AC1
AC2 AC2
2
STEP
AF2 AF2
AT1 AT1
12
BLUE BAG
• Place seat post support (AT1) on the side
floor support (AC1) and attach with two
bolts (M10x75), four
(10.2x22x2), and two nylon nuts (M10).
Partially thread pull pin onto seat post sup-
port.
• Slide the frame connection tube (AG3)
between the seat post support (AT1) and
swing arm support (AG2). Attach it to the
seat post support with two bolts (M10x10)
and two flat washers (10.2x22x2). Attach
the opposite end to the frame connection
tube with two bolts (M10x120), four flat
washers (10.2x22x2), and two nuts (M10).
• Slide the foot support base (AH1) onto
foot support tube (AC2). Tighten pull pin in
one of the adjustment locations of tube.
Place end of support tube (AC2) into
bracket on seat post support (AT1). Attach
seat post support end with one bolt
(M10x65), two flat washers (10.2x22x2),
and one nylon nut (M10). Attach the
opposite end to the floor support (AC2)
using one bolt (M10x25) and one flat
washer (10.2x22x2).
• Attach the dual pulley bracket assembly
(AF2) onto the swing arm support, with
plate side facing as shown in diagram.
Use two bolts (M10x120), four flat washers
(10.2x22x2), and two nylon nuts (M10)
to secure.
AG3 AG3
flat washers