Vision Fitness ST740 Owner's Manual page 11

Stickers
AC1 AC1
1
STEP
AG1 AG1
11
ORANGE BAG
NOTE: During assembly, it is recommended
•
to ensure that all bolts are in place and
partially threaded before completely
tightening any one bolt. During assembly
steps 1 thru 5, do not completely tighten
any bolts until completion of Step 5.
• Lay the side floor support (AC1) with the
pads face down. Place the center floor
support (AG1) against the side support,
lining up with holes in center of the side
floor support (make sure the colored stickers
are side by side on AC1 & AG1). Place
one flat washer (10.2x22x2) on each of
two bolts (M10x70) and slide through
holes, securing with one flat washers
(10.2x22x2) and one nylon nut (M10) on
each bolt.
• Place the swing arm support (AG2)
against the holes of the center floor
support. Attach with two bolts (M10x70),
four flat washers (10.2x22x2), and two
nylon nuts (M10).
• Attach the flat bracket (G10) to the
inside of the swing arm support (AG2)
using two bolts (M10x120), four flat
washers (10.2x22x2), and two nuts (M10).
G10 G10
AG2 AG2