Roland NOVA-MOD SH-101 Manual page 4

"adjusted" to swing 6 positions. The same clearance considerations must be made with respect to the key
action
however these switches will accept the correct Roland knobs.
2 100K Rotary Pots. (Radio Shack units work fine but 3" long shafts must be cut. As well, pins must be
flattened to prevent interference with keyboard action, shims may be required to lower keyboard.)
Roland pots (pn 13219274
must be made with respect to the key action however these pots will accept the correct Roland knobs.
1 DPDT Switched 1/4" jack.
2 1/4" Jacks with shorting contact
4 1/4" Jacks
1 SPDT toggle switch with center off position
1 4.7 uF 10V cap.
1 150K resistor
3 100k resistor
1 50k resistor
4 knobs (Roland PN 016H071)
NOVA-MOD Instruction:
note: There are only four circuit board assemblies inside an SH-101 that will be referred to in this instruction..
They are formally referred to as the Control Board, Synth Board, Bender Board, and Jack Board (a). (The
Control Board contains most of the sliders and switches. The Synth Board contains most of the electronic
components. The Bender Board is small and resides near the bender. The Jack Board has the CV and Gate
1/8" jacks connected to it). There is also the Keyboard (the assembly with the black and white piano keys). Read
Important Points before starting!!
EVH-5XAP20A15) may be used. The same clearance considerations