Roland NOVA-MOD SH-101 Manual page 13

1/8" to 1/4" Jack Upgrade
1. Desolder and remove Gate and CV Jacks.
2. Cut out circuit board as indicated by dashed line
3. Attach jacks as follows:
Gate out is a 1/4" 2 conductor jack. Its sleeve goes to ground. It's tip goes to pin46.
CV out is a 1/4" 2 condutcor jack. Its sleeve goes to ground. It's tip goes to pin 43.
Gate in is a 1/4" 2 conducor jack with shorting contact (Contact opens upon inserting
a 1/4" plug. Its sleeve goes to ground, it's tip goes to pin 44 and its shorting contact
goes to pin 46.
CV in is a 1/4" 2 conducor jack with shorting contact (Contact opens upon inserting
a 1/4" plug. Its sleeve goes to ground, it's tip goes to pin 45 and its shorting contact
goes to pin 43.
4. Jumper across ground trace that was cut during circuit board cutting.trace is indicated in figurexx.
5. Install and test for clearance by inserting 1/4" plugs.
Gate In
CV Out
GateOut
40
CVIn
49
Jackboard