Garmin G5 User Manual page 28

Installation Manual
1.3.4.2 UNIT MOUNTING
For final installation and assembly, refer to the outline and installation drawings in
Section 1.3.7.
1) Mount the G5 in a suitable location using the installation kit (Table 1-5) per
the requirements in Section 1.3.4.1.
2) Assemble the wiring harness and backshell connector.
3) Assemble the pneumatic hoses and connector.
4) Connect the CAN terminator if required (see Section 1.2.2.3).
5) Connect the backshell connector and hoses.
1.3.4.3 PNEUMATIC PLUMBING
The G5 has two ports that are connected to the aircraft's pitot and static pressure
sources. The ports are labeled on the unit using the abbreviations "P" and "S"
respectively (Figure 1-5). The pressure ports have 1/8-27 ANPT female threads. The
mating fitting must have 1/8-27 ANPT male threads.
NOTE: The temporary port plugs attached to the pressure ports on a new G5 are
not suitable for flight and must be removed prior to the installation of G5 into the
aircraft.
16
Garmin G5 User's Manual 190-02072-00 Rev. B