Garmin G5 User Manual page 19

1.2.2.1 WIRING HARNESS INSTALLATION
Use cable meeting the applicable aviation regulation for the interconnect wiring.
Any cable meeting specifications is acceptable for the installation. When routing
cables, observe the following precautions:
• All cable routing should be kept as short and as direct as possible.
• Check that there is ample space for the cabling and mating connectors.
• Avoid sharp bends in cabling.
• Avoid routing near aircraft control cables.
• Avoid routing cables near heat sources, RF sources, EMI interference sources,
power sources (e.g. 400 Hz generators, trim motors, etc.) or near power for
fluorescent lighting.
• Route the GPS antenna cable as far as possible away from all COM
transceivers and other antenna cables.
The installer shall supply and fabricate all of the cables. Electrical connections
are made through the D subminiature connector. Section 1.5 defines the electrical
characteristics of all input and output signals. Required connectors and associated
hardware are supplied with the connector kit.
Contacts for the connectors must be crimped onto the individual wires of the aircraft
wiring harness.
Table 1-2 lists contact part numbers (for reference) and recommended crimp tools.
CAUTION: Check wiring connections for errors before connecting any wiring
harnesses. Incorrect wiring could cause internal component damage.
190-02072-00 Rev. B Garmin G5 User's Manual
Installation Manual
7