Reset Button; Power - Extron electronics MPX 866 A User Manual

im Vertrieb von

Reset button

Power

www.camboard.de
CAMBOARD Electronics
Side Clip Down
Pins 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1&2 7&8
3&6 4&5
Figure 2-6 — RJ-45 connector and pinout tables
l
Reset button — The Reset button initiates four levels of reset of the
matrix switcher. Press and hold the button while the switcher is
running or while you power up the switcher for different reset levels.
See Performing soft system resets in chapter 3, Operation, for details.
• Events (mode 3) reset — Hold Reset for 3 seconds then release and push
again to toggle events monitoring on and off.
• IP settings (mode 4) reset — Hold Reset for 6 seconds then release and
push again to reset the switcher's IP functions.
N IP settings reset does not replace any user-installed fi rmware.
• Absolute (mode 5) reset — Hold Reset for 9 seconds then release and
push again to restore the switcher to the default factory conditions.
• Hard reset (mode 1) — Hold Reset while powering up the switcher to
restore the switcher to the default factory conditions.
m
AC power connector — Plug a standard IEC power cord into this connector to
connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
Tel. 07131 911201
MPX 866 A Media Presentation Matrix Switcher • Installation
Fax 07131 911203
Patch (straight) cable
Side 1
Pin Wire color
1 White-orange
2 Orange
RJ-45
connector
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Crossover cable
Side 1
Pin Wire color
1 White-orange
2 Orange
Twisted
Pairs
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
ce-info@camboard.de
Side 2
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 2
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
RESET
2-9