Table of Contents
Advertisement
H6 (Copy Only): DIP SW 1 2 4 at ON position, 3 at OFF position
L6 (Copy Only): DIP SW 1 2 at ON position, 3 4 at OFF position
If you adjust DIP SW to L6, all operation steps same as H6, the Recording
Speed will drop to 4x only.
6-1. Turn Rock Switch to position (CD Duplicator). LED will show version
number.
6-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
6-3. Duplicator will chk itself & get ready.
6-4. SmartDup ready, please inserts your CD title into your CD-ROM Drive &
Blank CD-R or CD-RW Media in CD-RW Writer.
6-5. LED Display showing final counts down, than LED showing H6 or L6.
6-5-1. If put in CD-RW Media with Data, CD-RW will eject & show Er.
6-6. LED Display showing CD-R or CD-RW Media maximum writing speed.
6-7. LED Display showing CD-R or CD-RW Media minimum writing time
remaining.
6-8. After writing success, Buzzer will Beep & eject CD-R media. LED showing
00.
6-8-1. If fail, LED will show: Er & eject CD-R Media also.
SmartDup VP-8220 Operation Manu
Power-On:
display firmware version number. (Buzzer 0.5s X1)
ex:
Self-Test:
Only one segment is running and display "rd" (ready)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
CD-R Maximum Writing Speed:
or
or
Remain minutes:
During Test or Copy mode. Flash every second
ex:
or
or
OK:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
-------------
--------------
or
7
Advertisement
Table of Contents
