Optional Interface Install Steps; Caution; New Firm Ware Download - VIPowER SmartDup VP-8220 Installation Manual

Install Steps:
1. Install CD-RW Writer & CD-ROM Driver in each CD-ROM box. Must put rubber
stand on each CD-ROM box.
2. CD-ROM Driver on top & CDR or CD-RW Writer on the bottom.
3. Plug in Duplicator Converter in both CD-ROM box connectors.
4. Plug in Power Cable in Duplicator Converter.
5. Plug in Power Cord to AC Power source (+90 ~ +250VAC).
6. 36 pin IDE cable connect between SmartDup & your PC or Note Book interface
port.
7. Turn your Power switch to (PC interface), LED Display will blinking.
8. Make sure install success.
9. You can start back-up your Data/ Audio/ Video.

Caution:

1. Make sure CD-RW burning software can recognize CD-RW writer.
2. Make sure your CD-R or CD-RW media acceptable maximum writing speed.
3. Maximum data transfer rate (byte/sec)
PCMCIA
4X 600K
6X 900K
8X 1200K
24X 2000K
32X 2000K
40X 2000K
4. CD-RW Driver Maximum Writing Speed through PC Interface:
(1.) PCMCIA: 8 x
(2.) CardBus: 16 x
(3.) USB 1.1 Version: 4 x
(4.) USB 2.0 Version: 20 x
(5.) FireWire IEEE 1394: 20 x
New Firm-Ware download:
1. Same as Install Step
2. Please down load new Firm-Ware from
www.vipower.com
3. Put CD-RW or CD-R media in to your CD-RW writer.
4. CD-RW writer as External CD-RW writer.
5. Start Copy New Firm-Ware to RW media.
6. Back to Page 3.
10
CardBus USB 1.1
600K 600K
900K 900K
1200K 900K
3600K 900K
3600K 900K
3600K 900K
1~ 8 at page 11.
to HDD.
USB 2.0
600K
900K
1200K
3600K
4800K
6000K
www.vipower.com.tw
SmartDup VP-8220 Operation Manu
FireWire
600K
900K
1200K
3600K
4800K
6000K
or