Table of Contents
Advertisement
H7(High Speed Auto Mode) DIP SW always at ON position
L7(Low Speed Auto Mode) DIP SW 1 2 3 at ON position, 4 at OFF position
If you adjust DIP SW to L7, all operation steps same as H7, the Recording
Speed will drop to 4x only.
7-1. Turn Rock Switch to position (CD Duplicator). LED will show version
number.
7-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
7-3. Duplicator will chk itself & get ready.
7-4. SmartDup ready, please insert your CD title into your CD-ROM Drive &
Blank CD-R or CD-RW Media in CD-RW Writer.
7-5. LED Display showing final counts down, than LED showing H7 or L7.
7-5-1. If insert CD-R Media with Data inside, it will eject & showing Er & if insert
CD-RW media with data, LED display will showing Er & CA, RW driver will
eject RW media.
7-5-2. If put RW tray in, than LED will show final count down & Erasing RW.
7-5-3.
7-6. LED Display showing CD-R or CD-RW Media maximum writing speed.
7-7. LED Display showing CD-R or CD-RW Media minimum writing time
remaining.
7-8. After writing success, Buzzer will Beep & eject CD-R media. LED showing 00.
7-8-1. If fail, LED will show: Er & eject CD-R Media also.
8
:
:
Power-On:
display firmware version number. (Buzzer 0.5s X1)
ex:
Self-Test:
Only one segment is running and display "rd" (ready)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
Erasing:
CD-R Maximum Writing Speed:
or
or
Remain minutes:
During Test or Copy mode. Flash every second
ex:
or
or
OK:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
------------------
or
or
SmartDup VP-8220 Operation Manu
-
Advertisement
Table of Contents
