Table of Contents
Advertisement
H1 (Upgrade firm-ware): DIP SW 3 4 at ON position, 1 2 at OFF position---
If you adjust DIP SW to L1, all operation step same as above, the Recording
Speed will drop to 4x only.
1 1. Turn Rock Switch to position (CD Duplicator). LED will show version number.
1-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
1-3. Duplicator will chk itself & get ready.
1-4. Please insert your new Firm-Ware CD title into your CD-ROM Drives,
operation step as below:
1-4-1. Please down load new Firm-Ware from www.vipower.com.tw or
www.vipower.com to HDD.
1 4 2. Switch your power switch to (PC interface)
1-4-3. Please check Optional Step (page 10)
1-4-4. Burning new Firm-Ware into your CD-R or CDR-W media.
1-5. LED Display showing final counts down. Than LED showing H1 or L1.
1-6. SmartDup will upgrade automatically.
1-7. After Upgrade success, Buzzer will Beep & eject Firm-Ware Title. LED
showing 00.
1-8. Showing new firmware version.
1-8-1. If fail, LED will showing: Er & eject CD-R Media, Buzzer will Beep also.
2
Power-On:
display firmware version number. (Buzzer 0.5s X1)
ex:
Self-Test:
Only one segment is running and display "rd" (ready)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
OK:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
SmartDup VP-8220 Operation Manu
Advertisement
Table of Contents
