Table of Contents
Advertisement
H5 (Test Only): DIP SW 1 3 4 at ON position, 2 at OFF position
L5 (Test Only): DIP SW 1 3 at ON position, 2 4 at OFF position---------------
If you adjust DIP SW to L5, all operation steps same as H5, the Recording
Speed will drop to 4x only.
5-1. Turn Rock Switch to position (CD Duplicator). LED will show version
number.
5-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
5-3. Duplicator will chk itself & get ready.
5-4. SmartDup ready, please insert your CD title into your CD-ROM Drive &
Blank CD-R or CD-RW Media in CD-RW Writer.
5-5. LED Display showing final counts down, than LED showing H5 or L5.
5-5-1. If put in CD-RW Media with Data; CD-RW will eject & show Er.
5-6. LED Display showing CD-R or CD-RW Media maximum writing speed.
5-7. LED Display showing CD-R or CD-RW Media minimum writing time
remaining.
5-8. After Testing success, Buzzer will Beep & eject CD-R media. LED showing
00.
5-8-1. If fail, LED will show: Er & eject CD-R Media also.
6
Power-On:
display firmware version number. (Buzzer 0.5s X1)
ex:
Self-Test:
Only one segment is running and display "rd" (ready)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
CD-R Maximum Writing Speed:
or
or
Remain minutes:
During Test or Copy mode. Flash every second
ex:
or
or
OK:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
--------------
or
SmartDup VP-8220 Operation Manu
Advertisement
Table of Contents
