Table of Contents
Advertisement
H2(1xCopy) DIP SW 2 4 at ON position, 1 3 at OFF position
L2(1xCopy) DIP SW 2 at ON position, 1 3 4 at OFF position
1xCopy Speed (H2 or L2) or CD-RW writer minimum writing speed.
2-1. Turn Rock Switch to position (CD Duplicator). LED will show version
number.
2-2. Than LED display showing: from 00,11, 22, 33, ......88, 99
2-3. Duplicator will chk itself & get ready.
2-4. SmartDup ready, please insert your CD title into your CD-ROM Drive &
Blank CD-R or CD-RW Media in CD-RW Writer.
2-5. LED Display showing final counts down, than LED showing H2 or L2.
2-6. LED Display showing CD-R or CD-RW Media writing speed or depend on
CD-RW writer minimum writing speed.
2-7. LED Display showing CD-R or CD-RW Media minimum writing time
remaining.
2-8. After Upgrade success, Buzzer will Beep & eject CD-R media. LED
showing 00.
2-8-1. If fail, LED will showing: Er & eject CD-R Media, Buzzer will Beep also.
SmartDup VP-8220 Operation Manu
Power-On:
display firmware version number. (Buzzer 0.5s X1)
ex:
Self-Test:
Only one segment is running and display "rd" (ready)
Count Down:
After drives & discs ready in current mode, wait for
5 seconds. (Buzzer 0.2s X1)
ex:
CD-R Maximum Writing Speed:
Remain minutes:
During Test or Copy mode. Flash every second
ex:
or
OK:
After Self-Test or Test or Erase or Copy. (Buzzer 1sX2)
FAIL:
After Self-Test or Test or Erase or Copy or Upgrade. (Buzzer 0.2X3)
---------------
----------------
or
3
Advertisement
Table of Contents
