Whirlpool CAM2752 Installation Instructions Manual page 25

REVERSING DRYER DOOR SWING
3. Move hinge to other side. Reinstall 4 screws.
Reverse the strike
1. Use a small fiat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the plugs, without scratching dryer surface, and lift
up strip.
4. Reinstall plug strips on opposite side of the inner door.
2. Remove the strike using a Phillips screwdriver.
5. Check for fingerprints on the glass. Clean if necessary.
Replace the Door Assembly
1. Place the inner door assembly inside the outer door
assembly.
2. Reassemble the inner and outer door assemblies with the
6 screws.
3. Insert strike on the opposite side.
Reinstall the door
1. Partially insert the third screw from the top; then slide the
hinge onto this screw while hooking the hinge into the front
panel hole. Reattach door to dryer front panel with the
remaining three screws.
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.
25