Whirlpool CAM2752 Installation Instructions Manual page 21

Commercial dryer gas or electric
Table of Contents

Advertisement

Available languages

Available languages

ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting
4-Wire
Connection:
Direct
Wire
Connecting
Ground and Neutral Wires (cont.)
2. Connect ground and neutral wire to center terminal
block.
Connecting
Direct
Wire
Ground
3. Connect
ground
wire
(green or bare) with
external
ground
connector
screw.
Connecting
Remaining Wires
4. Connect remaining wires to outer terminal
block.
Connecting
3-Wire Connection:
Direct Wire
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
Direct wire cable must have 5 ft. (1.52 m) of extra length so
dryer can be moved if needed.
Strip 3t/2 '' (89 mm) of outer covering from end of cable. Strip
insulation back 1" (25 mm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape ends of
wires into a hook shape.
Connecting
Neutral Wire
1. Loosen or remove center terminal
block screw.
I
2. Connect
neutral
wire to center
terminal
block.
3. Connect remaining wires to outer terminal
block.
21

Advertisement

Table of Contents
loading

Table of Contents