Use a heavy metal vent,
Do not use a plastic vent,
Do not use a metal foil vent,
Failure to follow these instructions can result in death
WARNING: To reduce the risk of fire, this dryer MUST BE
IMPORTANT: Observe all governing codes and ordinances.
45 ° elbows provide better airflow than 90 ° elbows.
Use clamps to seal all joints.
Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into interior
of duct and catch lint. Do not use duct tape.
Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, attic, crawlspace, or a concealed space
of a building. Only rigid or flexible metal vent shall be used for
4" (102 ram) heavy, metal exhaust vent
Only a 4" (102 mm) heavy, metal exhaust vent and clamps
may be used.
Do not use plastic or metal foil vent.
venting can cause moisture
and lint to collect
may result in:
 Moisture damage to woodwork,
furniture, paint, wallpaper,
problems and health problems.
Rigid metal vent:
for best drying performance
and to avoid
crushing and kinking.
Flexible metal vent: (Acceptable only if accessible to clean)
Must be fully extended and supported
in final dryer
Remove excess to avoid sagging and kinking that may result
in reduced airflow and poor performance.
Do not install in enclosed walls, ceilings, or floors.
The total length should not exceed 73/4 ft. (2.4 m).
NOTE: If using an existing vent system, clean lint from entire
length of the system and make sure exhaust hood is not
plugged with lint. Replace plastic or metal foil vents with rigid
metal or flexible metal vents. Review "Vent System Chart" and
if necessary, modify existing vent system to achieve best drying