Settings For Dante Controller - Yamaha Nuage Setup Manual

Tip:
If you are using more than one Nuage Fader, add them in order, starting with the one you want to
treat as the first Fader (eg, if you have two Faders next to each either, treat the left one as Fader 1
and the right one as Fader 2). To select the right unit from the Device/DAW List, click the Identify
button; this will cause an LED on that unit to blink briefly. If for some reason the Faders have been
added to the Workgroup in the wrong order, click the down-arrow button to remove all the Faders
from the Workgroup and then start over.
Add all the devices to the Workgroup, and then confirm that the green Active indicator appears.

6-7. Settings for Dante Controller

There are two main types of patch settings related to Nuage audio input/output, and they both need
to be set correctly. The first is patching in Dante, the second is patching in NUENDO. Set up
patching in Dante first by launching Dante Controller. (Details for patching in NUENDO will be
explained in 6-10.)
【All devices added to the workgroup active】
97