Yamaha Nuage Setup Manual page 103

Dante Accelerator inputs. To set up a patch, just click on the box at the intersection of the
patch-point. Continue until all patches are set.
TIPS：
With only the first 16 channels, clicking the intersection point between device names while holding
down the Control key will patch the inputs and outputs for those 16 channels one at a time, in order.
Clicking while holding down the Control and Shift keys will remove all the patches for those 16
channels at once. The 17th channel and beyond need to be patched manually, one at a time. It can take
a few seconds for each patch to be set, so wait for the setting process to finish before clicking again.
The figure above shows the Dante Accelerator outputs patched to the I/O inputs; you will also need to
match up the patches between each Nuage I/O output and Dante Accelerator input.
TIPS：
When patching Nuage I/O and Dante Accelerator, it is necessary to follow the ID order from the first
unit, starting from 1-16, then 17-32 and 33-48. (If the patch is not in order, Direct Monitoring,
Surround Processor and the linkage with SyncStation may not work properly.
【Patch Dante Transmitters and Receivers】
103