Openpath OP-SH-24V Installation Manual page 33

Regulatory
All national and local electrical codes apply.
UL 294
When the Openpath Smart Hub 4 Door Controller is enclosed in the E1 enclosure and
powered by FPO75, the following performance levels are defined for the access
control unit as per UL 294:
Attack:
Endurance:
Line Security:
Standby:
CAN/ULC 60839-11-1-16 GRADE 1
For C-UL Listed applications, the unit shall be installed in accordance with Part 1 of
the Canadian Electrical Code.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. To comply with FCC RF exposure compliance
requirements, a separation distance of at least 20 cm should be maintained
between the antenna of Openpath Smart Reader(s) and persons during operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
OP-RLF-STD/MULB: FCC ID: 2APJVOPRLF
OP-RHF-STD/MULB: FCC ID: 2APJVOPRHF
Version 1.8
Level I
Level I
Level I
Level I
©​ Openpath 2020 Page 33