Cleaning; Flushing The System - ECOLOBLUE 30 Series Manual

Figure 7
. Rotate RO Filter counter-clockwise.

Cleaning

Clean the bottom storage tank. See detailed instructions in cleaning the bottom tank on page 29.

Flushing the System

1
Fill the bottom tank until full with municipal water. Plug in the Appliance. Appliance
should power on, if not, turn the power ON by pressing the POWER button on the front
display of the Appliance.
2 The pump will switch on and pump the water until the bottom tank depletes to a level 2.
3 MAKE SURE TO TURN OFF THE APPLIANCE EVERYTIME YOU FILL THE BOTTOM TANK
OR IT MIGHT RESULT IN A LEAK WARNING. Overfilling the bottom tank also
might result in a leak triggering the leak detector.
4 Turn the power OFF by pressing and holding POWER button.
5 Drain water from the rear HOT Water Drain outlet. The HOT Water drain has a screw
cap and a rubber plug, please remove both. When draining complete, replace plug and
cap.
6 Turn the power ON and the Appliance will now begin generating water. Maximum
generation may take up to 72 hours.
www. EcoloBlue.com | 800-691-6043 | 1-925-231-0206
Figure 8
Lower Reverse Osmosis into place.
17