Loudspeaker (Sp1, Sp2) (L-Ch)-2 - Sony HT-ST9 Service Manual

HT-ST9

2-32. LOUDSPEAKER (SP1, SP2) (L-ch)-2

7 loudspeaker (18 mm)
(tweeter (front Lch))
(SP1)
6 terminal
[blue]
3 terminal
(narrow side)
[black]
2 Lift up the loudspeaker
(SP2) in the direction
of the arrow.
Top side
Left side
– Left speaker block front view –
ow to install the speaker wire
terminal [blue]
(tweeter)
groove
terminal [blue]
(MOUNTED board)
40
1 Lift up the loudspeaker (SP1)
in the direction of the arrow.
6 terminal
[black]
4 loudspeaker (6.5 cm)
(woofer (front Lch))
(SP2)
3 terminal (wide side)
[red]
Bottom side
Note 2: When installing the speaker wire,
make the position of caulking of
terminals is upside.
groove
– Cabinet (L) block top view –
Installation direction for
the woofer speaker wire
Note 1: When installing the speaker wire,
make the position of caulking of
terminals is outside.
OK
Caulking is
outside.
5 baffle (L)
Right side
Caulking is upside.
screw boss
speaker wire
groove
(woofer)
terminal [black]
(tweeter)
NG
Caulking is
inside.
groove