S6000-On System Installation - Dell Neworking S6000-ON Installation Manual

Figure 9. Four-post threaded configuration
2 Attach the front and rear flanges for each rail to the post flanges with two user-supplied screws at each end, item 2.

S6000-ON system installation

You can mount the system in the 1U front-rack, four-post or two-post configurations. The following is an example of a front-rack
configuration.
For the 1U two-post flush or center configurations, slide the system into the rails in the same manner as the four-post configurations.
Installing a 1U Front-Rack
You must configure the rails that are attached to the system.
1 Attach the switch rails (inner chassis members) to the S6000-ON system. The following illustration, item 3, shows the detail for the
front standoff with the locking tab.
20 S6000–ON installation