Ac Power Supply Replacement - Dell Neworking S6000-ON Installation Manual

Figure 13. PSU installation
1—PSU
2—Slot
When you install the PSU correctly, it snaps into place and is flushed with the back of the switch.
4 Plug in the appropriate AC three prong cord from the switch PSU to the external power source.
5 Repeat steps 1 through 4 if you have a second power supply using the second PSU slot on the S6000-ON system.
NOTE: The S6000-ON powers up when the cables are connected between the power supply and the power source.

AC power supply replacement

CAUTION: Disconnect the power cord before removing the power supplies. Also, disconnect all power cords before servicing.
NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S6000–
ON chassis.
NOTE: If a PSU fails, you must replace the entire unit. There are no field serviceable components in the PSU. To request a
hardware replacement, see
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell EMC recommends using power supply 2 (PSU2) as
the blank plate slot.
1 Disconnect the power cable from the PSU.
2 Use the grab handle to slide the PSU out of the power supply bay.
3 Use the grab handle on the replacement PSU to slide it into the power supply bay.
4 Attach the power cord to the replacement PSU.
NOTE: The system powers up when the cables are connected between the power supply and the power source.
26 Power supplies
Technical Support.