Installation Of Indoor Unit - Gree Cozy Owner's Manual

Installation of Indoor Unit

1.Mounting plate should be installed horizontally. As the water tray's outlet for the indoor unit is two-way
type, during installation, the indoor unit should slightly slant to water tray's outlet for smooth drainage of
condensate.
2.Fix the mounting plate on the wall with screws.
3.Be sure that the mounting plate has been fixed firmly enough to withstand about 60 kg. Meanwhile, the
weight should be evenly shared by each
1.Slant the piping hole (
outdoor side.
2.Insert the piping-hole sleeve into the hole to prevent the connection piping
and wiring from being damaged when passing through the hole.
Connect the drain hose to the outlet pipe of the indoor unit
1.
Bind the joint with rubber belt.
2. Put the drain hose into insulating tube.
3. Wrap the insulating tube with wide rubber belt to prevent
the shift of insulating tube. Slant the drain
slightly for smooth drainage of
Note: The insulating tube should be connected reliably
with the sleeve outside the outlet pipe. The drain hose
should be slanted downward slightly, without
distortion, bulge or fluctuation. Do not put the
outlet in the water.
Installation of Mounting Plate
screw.
Wall
Mark on the middle of it
Space
to the
wall
1 0 5 m m
above
Left
Φ55mm or Φ70mm
(Rear piping hole)
Drill Piping Hole
55 or Ф70) on the wall slightly downward to the
Ф
Installation of Drain Hose
condensate.
Gradienter
Φ55mm or Φ70mm
Fig.5
(Rear piping hole)
.
outlet pipe of
indoor unit
hose downward
21
Wall
Space
to the
wall
1 0 5 m m
above
Right
Indoor
Wall pipe
drain hose
rubber belt
outlet pipe of
indoor unit
rubber belt
rubber belt
outlet pipe of
indoor unit
connected
bulge
Outdoor
Seal pad
Ф55
or
Ф70
outlet pipe of
indoor unit
drain hose
insulating tube
insulating tube
distortion
Flooded