Wall Mounting The Ied - ABB Relion 650 Series Installation Manual

Section 5
Mounting
5.3.3

Wall mounting the IED

1. Drill four screw holes according to the dimensional drawing.
2. Mount the mounting brackets using the required screws.
3. Remove the plastic plugs from the side of the IED.
4. Fit the IED securely between the mounting brackets by using the required screws.
5. Tighten the screws.
D
GUID-E8BD96E7-EF70-4287-BA2E-1ADD385AB9B8 V1 EN-US
Figure 9:
A 10.63 inches (270 mm)
B 9.94 inches (252.5 mm)
C ∅0.27 inches (6.8 mm)
D 10.59 inches (268.9 mm)
E
F
G 0.51 inches (13 mm)
26
A
B
E
Wall mounting the IED
1 Mounting bracket
2 Screw
7.5 inches (190.5 mm)
11.65 inches (296 mm)
Minimum of 50 mm space is needed between the two kits.
It is recommended to connect wires and terminal strips before IED is fitted on
mounting brackets.
© Copyright 2011 ABB. All rights reserved
2
1
1MRK 514 014-UUS A
GUID-C6B7126A-6B94-4ECD-AA40-A7D84548F023 v4
650 series
Installation manual