Siemens SINUMERIK 828D Training Manual page 183

Alarm configuration.
The following shows information required for setting and configuring alarms.
Alarm Number
700000 DB1600DBX0.0
700001 DB1600DBX0.1
700002 DB1600DBX0.2
700003 DB1600DBX0.3
700004 DB1600DBX0.4
700005 DB1600DBX0.5
700006 DB1600DBX0.6
700007 DB1600DBX0.7
700008 DB1600DBX1.0
700009 DB1600DBX1.1
700010 DB1600DBX1.2
etc
etc
700247 DB1600.DBX30.7
Below:-An example of how Alarm 700000 might be activated via input I6.5
The configuration machine data is used to determine how the controller reacts to that
particular alarm. Each alarm has a machine data assigned to it for this purpose.
Machine Data 14516 functionality:-
14516[xx] Bit 7
Acknowl- Power
edge/Effect off
The functionality of the machine data is in two parts.
Bits 0 to 4 determine how the controller reacts to that particular alarm, while Bits 6 & 7
determine how the alarm is acknowledged.
The MD is set via a bit pattern which is revealed when the MD is highlighted and the
"Select" key is pressed.
The bit is then activated with the "Select" or "Space" key and confirmed with the "OK"
soft-key
SINUMERIK 828D
Activation bit Configuration
Machine Data
14516[0]
14516[1]
14516[2]
14516[3]
14516[4]
14516[5]
14516[6]
14516[7]
14516[8]
14516[9]
14516[10]
etc
etc
14516[247]
Bit 6 Bit 5 Bit 4
Acknowl- PLC
edged by stop
DB1600.D
BX3000.0
Variable for extended
alarm function
DB1600.DBD1000
DB1600.DBD1004
DB1600.DBD1008
DB1600.DBD1012
DB1600.DBD1016
DB1600.DBD1020
DB1600.DBD1024
DB1600.DBD1028
DB1600.DBD1032
DB1600.DBD1036
DB1600.DBD1040
etc etc
etc etc
DB1600.DBD1998
Bit 3 Bit 2 Bit 1
Emer- Feed Read in
gency disable disable
stop
Page 3
Section 2
Notes
Bit 0
NC start
inhibit
B031
B031