Preparations; Installation - Magicfx STADIUM SHOT Manual

9. PREPARATIONS

Unpack the Stadium Shot. Dispose of the packaging material without harming the environment.
Inspect the machine for any damage. If damage is noticed this must be reported to MAGIC FX.
1.
2.
3.
TekSet
Rental S.r.l.
Version 1.0
Take a carton lifting core and lower this
to the bottom of the shooting tube to
close off the hole.
Check if the lifting core lies flat!
Now fill the shot pipe with the required
type(s) and colour(s) of confetti and/or
streamers.
For an extra effect try to mix streamers and
confetti!
When the shot pipe is fully filled you take,
for maximal effect, a pressure cap and
place this over the end of the shooting
tube to close it off.
Tape the edge of the pressure cap with
the special pressure cap tape.
Page 12
via GIUSEPPE DI VITTORIO 9
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW.TEKSET.IT
| STADIUM SHOT |
User documentation MAGICFX® Stadium Shot

10. INSTALLATION

Prepare the Stadium Shot for use as follows:
1.
2.
Page 13
via NAZARIO SAURO 13/A
20037 PADERNO DUGNANO (MI) ITALY
CONTACT US: (+39) 0291082905 - WWW.TEKSETRENTAL.IT
CAUTION:
The machine can be damaged if you do not follow the procedures
carefully.
DANGER WARNING:
The MAGICFX® Stadium Shot may only be installed by adults and
authorised persons.
Place the Stadium Shot on an even, solid
and stable surface.
Open the cover of the Stadium Shot.
| RENT: CONFETTI |