Replacing The Attachment - JVC DLA-VS2200ZG Instructions Manual

Replacing the Attachment

Attachment and the placement area
As default, an attachment for Area A (with "X" hole and stamp of "0°") is
0
attached on the lamp. Use the lamp as it is if you use with the angle in
Area A. And stick the Installation verification seal on the lamp cover to
avoid using in the wrong position.
Refer to p. 49 on how to stick the Installation verification seal.
Replace with the supplied attachment (with "+" hole and stamp of "90°")
0
if you use in Area B. In this case, replace the Installation verification seal.
After the replacement, keep the removed seal and attachment together.
0
Area A Attachment
Area B Attachment
"X" Hole
"+" Hole
45 °
Area A
Installation Verification Seal
"UPPER45°-DOWN90°"
Stamp of "0°"
Installation Verification Seal
"UPPER45°-90°&REVERSE"
Stamp of "90°"
Area B
90 °
30 °
Area B
-30 °
45