Table of Contents
Advertisement
Replacing the Attachment
Attachment and the placement area
At the time of shipment, the lamp comes with an Area A attachment (X
0
mark and "0°" marking). For Area A, make use of the lamp that is attached
at the time of shipment. Also, attach an installation verification sticker to
the lamp cover to prevent its use in an incorrect posture.
For details on how to attach the installation verification sticker, please
refer to p. 46.
For use in Area B, replace the Area A attachment with the supplied
0
attachment (+ mark and "90°" marking). In this case, change the
installation verification sticker as well.
After the replacement, keep the removed sticker and attachment
0
together.
Use in areas other than Area A and Area B is prohibited.
0
Area A Attachment
"X" Hole
.
Area B Attachment
"+" Hole
.
42
Installation verification sticker
"UPPER45°-DOWN90°"
Stamp of "0°"
Installation verification sticker
"UPPER45°-90°&REVERSE"
Stamp of "90°"
Area B
45 °
Area A
45°
90°
90°
45°
90 °
30 °
Area B
-30 °
30°
-30°
Advertisement
Table of Contents
