Function
Off Timer
For setting the timing to power off the unit automatically ("1 Hour", "2 Hours", "3 Hours", or "4 Hours") when it is not
operated for a period of time.
High Altitude Mode
Set to "On" when using the projector at a location of low atmospheric pressure (higher than 900 m above sea level).
Communication Terminal
For setting the external control terminal to be used to "RS-232C" or "LAN".
Network
Setting
DHCP Client
On
Off
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
Remote Code
For changing the remote control code.
You need to configure the remote control according to the settings of this unit.
0
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to "A"
0
The backlight of the remote control blinks 2 times: change the remote control code to "B"
0
Setting
A
B
Lamp Reset
For resetting the lamp time to "0".
Æ "Resetting the Lamp Time" (p. 50)
Obtains the IP address automatically from the DHCP server inside the connected
network.
For configuring the network settings manually.
For configuring the IP address.
For configuring the subnet mask.
For configuring the default gateway.
Displays the MAC address of the unit.
Applies the network settings.
Change the remote control code from "B" to "A".
Change the remote control code from "A" to "B".
Description
Description
41