TSI Instruments BlueSky Quick Start Manual

Air quality monitor

Hide thumbs Also See for BlueSky:

Table of Contents

Download this manual

BlueSky

™

AIR QUALITY MONITOR

Quick Start Guide

Table of Contents

Need help?

Do you have a question about the BlueSky and is the answer not in the manual?

Page 1 BlueSky ™ AIR QUALITY MONITOR Quick Start Guide...
Page 2 Inventory You Will Need Optional Four (4) screws are required (not supplied) if installing on wall, fence, wood board, etc.
Page 3 1) Set Up Connect power supply (USB end) to BlueSky™ Air Quality Monitor. Connect power supply (other end) to a power outlet. To configure BlueSky monitor wireless settings, slide switch towards the settings gear icon. Status LED light will flash 1 time/second.
Page 4 Please move switch to operate position Note: If using a mobile device, make sure mobile data is turned off. Note: Then network needs to be a wireless network with access to the Internet. The BlueSky monitor will use this network to connect to the cloud.
Page 5 2 flashes/second B) No Internet: 3 flashes/second Please note that, as long as the BlueSky monitor is not in setup/configuration mode, data will be automatically saved to the pre-installed SD card. Once the SD card data capacity is reached, it will begin overwriting data.
Page 6 3B ) To install on pole Feed plastic ties through slots in bracket. Slip USB cord between plastic tie and bracket, secure. Connect BlueSky™ Air Quality Monitor to power outlet. Status LED light will flash 1 time/second when successfully connected.