Replacing The Battery - ViewSonic PLED-W200 User Manual

Replacing the battery

For the first time use:
Remove the transparent insulation tape by pulling it before
use.
For battery change:
1. Push the catch to the left and remove the battery holder.
2. Remove the old Lithium coin cell and install new one
(CR2025). Ensure that the side with the mark "+" is up.
3. Push the battery holder back into the remote control
until you feel a click.
Caution
• Risk of explosion if battery is replaced by an incorrect type.
• Dispose of used batteries according to the instructions.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
Note
• Keep the battery out of the reach of children.
• Do not recharge the battery or expose the battery to fire or water.
• Do not dispose the used battery along with household waste. Dispose used batteries
according to local regulations.
• Danger of explosion may happen if batteries are incorrectly replaced. Replace only with
the same type recommended by the manufacturer.
• Battery should not be in or near to fire or water, keep batteries in a dark, cool and dry
place.
• If suspect battery leakage, wipe out the leakage and then replace a new battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
Downloaded From projector-manual.com Viewsonic Manuals
13