Advertisement
Quick Links
NATIONAL
INSTRUMENTS @
The
Sofrware
k
the
Instrument
@
SCXI-1348
DIO-32F
Cable Assembly
Installation
Guide
Part Number 320620-01
This guide describes how to install the SCXI-1348 cable assembly between an SCXI module and
I
an AT-DIO-32F,
MC-DIO-32F,
or NB-DIO-32F
data acquisition board. In addition to the
SCXI-1348 kit contents, you will also need an SCXI chassis, an SCXI module, a computer, a
DIO-32F data acquisition board, and a small flathead screwdriver.
Introduction
With the SCXI-1348 cable assembly, you can connect a digital I/O SCXI module to your
DIO-32F data acquisition board. The DIO-32F works with the SCXI-1160,
SCXI-1161,
SCXI- 1162, and SCXI- 1163 modules.
If you have a newly released module or a data acquisition board other than a DIO-32F, contact
National Instruments for information on your cable needs.
The SCXI-1348
cable assembly consists of an adapter board and an NB4 50-conductor shielded
ribbon cable that connects the adapter board to a DIO-32F data acquisition board. The adapter
board converts the signals from the DIO-32F I/O connector to the pinout that a digital SCXI
module rear signal connector uses. To extend the unconverted signals of the DIO-32F to another
module or to an SCXI-1180 feedthrough panel, you can use the male breakout connector that is
on the center of the adapter board.
What Your Kit Should Contain
The contents of the SCXI-1348
cable assembly kit are as follows:
I
Kit Name and
Part Number
Component
I
Component
Part Number
I
SCXI- 1348 Cable
Assembly (776574-48)
Cable adapter
Two small screws
1 m NB4 shielded 50-pin ribbon cable.
SCXI-1348 DIO-32F Cable Assembly
Installation Guide
182252-01
742413-01
180554-10
320620-01
If your kit is missing any of the components, contact National Instruments.
0 1993 National Instruments
Corporation.
All rights reserved.
June 1993
Advertisement
