Problems With Your Wine Cooler; Troubleshooting Guide; Care And Maintenance - Scandomestic SV 80 User Manual

Install the decorative frame (SV 80)
Take out the decorative frame and the brackets from the accessories
box. Fix the brackets to the cabinet with the screws provided and fix
both sides of the decorative frame to the brackets with the 2 supplied
screws as shown in below diagram.

CARE AND MAINTENANCE

Cleaning Your Wine Cooler
• Turn off the power, unplug the appliance, and remove all items
including shelves and rack.
• Wash the inside surfaces with a warm water and baking soda
solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning
area of the controls, or any electrical parts.
• Wash the outside cabinet with warm water and mild liquid
detergent. Rinse well and wipe dry with a clean soft cloth.
Power Failure
• Most power failures are corrected within a few hours and should
not affect the temperature of your appliance if you minimize the
number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps
to protect your contents.
Vacation Time
• Short vacations: Leave the Wine Cooler operating during vaca-
tions of less than three weeks.
• Long vacations: If the appliance will not be used for several
months, remove all items and turn off the appliance. Clean and
dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary.
Moving Your Wine Cooler
• Remove all items.
• Securely tape down all loose items (shelves) inside your appli-
ance.
• Turn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the upright position during
transportation. Also protect outside of appliance with a blanket,
or similar item.
Energy Saving Tips
• The Wine Cooler should be located in the coolest area of the
room, away from heat producing appliances, and out of the
direct sunlight.

PROBLEMS WITH YOUR WINE COOLER?

You can solve many common Wine Cooler problems easily, saving you
the cost of a possible service call. Try the suggestions below to see if
you can solve the problem before calling the servicer.

TROUBLESHOOTING GUIDE

Wine Cooler does not operate.
- Not plugged in.
- The appliance is turned off.
- The circuit breaker tripped or a blown fuse.
Wine Cooler is not cold enough.
- Check the temperature control setting.
- External environment may require a higher setting.
- The door is opened too often.
- The door is not closed completely.
- The door gasket does not seal properly.
Turns on and off frequently.
- The room temperature is hotter than normal.
- A large amount of contents has been added to the wine cooler.
- The door is opened too often.
- The door is not closed completely.
- The temperature control is not set correctly.
- The door gasket does not seal properly.
The light does not work.
- Not plugged in.
- The circuit breaker tripped or a blown fuse.
- The bulb has burned out.
- The light button is "OFF".
Vibrations.
- Check to assure that the Wine Cooler is level.
The Wine Cooler seems to make too much noise.
- The rattling noise may come from the flow of the refrigerant,
which is normal.
- As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in your Wine Cooler.
- Contraction and expansion of the inside walls may cause pop-
ping and crackling noises.
- The Wine Cooler is not level.
The door will not close properly.
- The Wine Cooler is not level.
- The door was reversed and not properly installed.
- The gasket is dirty.
- The shelves are out of position.
14