Advertisement
8. Reset to Factory Default
a. Disconnect power from the unit
b. Press and hold # key while powering the unit back up
c. On hearing two "Beeps" release # key, system is now
back to factory settings
9. Anti-Tamper Alarm
The unit uses a LDR (light dependent resistor) as an
anti-tamper alarm. If the keypad is removed from the cover,
the tamper alarm will operate.
10. Sound and Light indication
Operation Status
Power on
Standby
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming mode
Open the door
Alarm
11. Detailed Programming Guide
11.1 User Settings
To enter the programming mode
To exit from the programming mode
Note that to undertake the following programming, the master user must be logged in
To change the master code
To add a Pin user
Standalone Keypad Installation Instructions
Note: Only the installer data is restored, user
data will not be affected.
Red Light
Green Light
-
Bright
Bright
-
-
Bright
-
Bright
-
Bright
-
Bright
Bright
*
Master code #
999999 is the default factory master code
*
0
New code
The master code can be 6 to 8 digits long
1
User ID number
The ID number is any number between 1 & 2000.
The PIN is any four digits between 0000 & 9999 with
the exception of 1234 which is reserved. Users can be
added continuously without exiting programming mode
as follows:
1 User ID no 1
Page 4 of 6
Yellow Light
-
-
-
-
-
-
-
-
-
-
Bright
-
-
-
-
-
-
#
New code #
#
PIN
# PIN # User ID no 2 # PIN #
Buzzer
Beep
-
Beep
Beep
Beep/Beep/Beep
-
Beep
Beep
Beep
Alarm
#
Advertisement
