Hydraulic Oil Filter Restriction Switch Removal And Installation; Hydraulic Oil Temperature Sender Removal And Installation - New Holland LS160 Manual

Hide thumbs Also See for LS160:

Table of Contents

HYDRAULIC OIL FILTER RESTRICTION

Op. 55 414 24

1. Support the boom on the boom lock pins.

2. Open the rear door, raise the top engine shield

and remove the right engine side shield to access

3. Remove the DKGN/O wire, 1.

4. Remove the restriction switch, 2, from the filter

INSTALLATION

1. Install the switch into the filter base.

2. Attach the DKGN/O wire to the switch terminal.

HYDRAULIC OIL TEMPERATURE SENDER

Op. 55 414 20

1. Remove any attachment from the boom face

plate and support the boom on the boom

Never work under a raised boom unless it is

properly supported by the boom lock pins.

2. Raise the operator's seat and latch in the raised

latched position.

Never work under a raised seat unless it is

securely latched in the raised position.

3. Drain the hydraulic reservoir.

Remove the rear engine belly pan hardware, 1,

and lower the pan from the loader.

Use a floor jack to support the belly pan and

prevent serious injury.

SECTION 55 - ELECTRICAL SYSTEM

Troubleshooting