New Holland LS160 Manual page 395

Hide thumbs Also See for LS160:

Table of Contents

Install the wear plate assembly, 1, with the gas-

ket/seal side towards the pump mounting plate

with the mid section cut away on the suction side,

2, of the pump.

5. Install the drive shaft, 1, making sure to engage

the splines inside the hydrostatic pump. Install

the idler gear assembly, 2, into the bushing. Ro-

tate the gears to help slide the idler gear into

NOTE: The drive shaft and gear, 1, must tbe properly

seated on the hydrostatic pump drive shaft splines

with the end of gear teeth against the wear plate.

Position the keyway, 3, up.

6. Install the pump body and back plate together, 1,

over the gear shafts, taking care not to disturb the

seals between the pump body and backplate.

SECTION 35 - HYDRAULIC SYSTEM

Troubleshooting