New Holland LS160 Manual page 279

INSPECTION
1. Inspect the handle pivot bearings, 1; replace if
worn or damaged.
2. Inspect the control handle for excessive wear or
bends in the bearing mounting plates, 2, and
pivot stub shafts, 3.
REASSEMBLY
1. Slide the handle sideways over the stub shafts.
2. Install the bearings, 1, on the handle. Install shim
washers, 2, to center the handle in the slot, 3.
3. Install shim washers, 4, to reduce side play on
the stub shafts. Retain the shims on the stubs
shaft with a roll pin, 5.
4. Slide the boot, 6, over the handle and tighten the
boot securing bolts.
5. Install a new hand grip, 7, if grip is worn.
REINSTALLATION
1. Place the handle assembly in the unit and install
the five handle mounting bolts, 1, and tighten
securely.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-99
3
2 1
7
6
1
4
3
2
1
228
3
229
1
230