9. Reassemble the parking brake:
–
Clean the old sealant from the brake hard-
ware.
–
Install the spacer plate, 2, and brake friction
puck, 1, into caliper at 3.
NOTE: The spacer plate is thinner than the brake
friction puck and must be inserted into the caliper
first.
–
Install the inside brake disc, 1.
–
Put a bead of noncorrosive sealant around
the head of the caliper bolts and install from
the inside of loader.
–
Install spacers, 2, on bolts and center section
of caliper, 3.
–
Install outer brake disc, 4.
–
Install outer section of caliper, 1, and attach
with hardware previously installed and tight-
en to 70 N·m (52 ft. lbs.).
–
Put a bead of sealer around the end of the
motor coupler and install the brake disc re-
taining bolt and flat washer, 2, and tighten.
–
Engage the parking brake and torque the re-
taining bolt to 35 N·m (26 ft. lbs.).
SECTION 44 - AXLES AND WHEELS
44-21
45
46
47