Advertisement
IMPORTANT! READ BEFORE UNBOXING
Steps:
1. Two (2) people are required for the initial setup.
2. Carefully unpack your new walk thru metal detector.
3. After unpacking, you should have the following:
Two (2)
One (1)
One (1)
One (1)
Eight (8)
One (1)
4. On a Flat Clean surface, set the head module on the pad provided.
The head unit should be face up with the LED screens facing the
ceiling. Once the head module is positioned correctly; insert the keys
to open and access the motherboard.
Quick start guide for:
MD-6 & MD-6 ADA
LED Uprights/legs
Head Module & Keys
Power Cord
5mm (Hex) Allen key
Bolts & Nuts
Operation Manual
Advertisement
Table of Contents
Related Manuals for Metal Defender MD-6
Summary of Contents for Metal Defender MD-6
- Page 1 IMPORTANT! READ BEFORE UNBOXING Quick start guide for: MD-6 & MD-6 ADA Steps: 1. Two (2) people are required for the initial setup. 2. Carefully unpack your new walk thru metal detector. 3. After unpacking, you should have the following:...
- Page 2 5. Attach the Left and Right Uprights/Legs using the Bolts Provided - DO NOT OVER TIGHTEN 6. Connect the commutation cables from each leg to the corresponding spot on the motherboard. Next connect the white led strip from each leg to the corresponding spot on the motherboard. Once both of the connectors are secured and fastened in place connect the master power plug to whichever leg you would prefer the power cord to be running from.
Need help?
Do you have a question about the MD-6 and is the answer not in the manual?
Questions and answers