ETI NETCOM ADH Assembly Replacement Procedure page 8

14.
With the ground wire, power
connector and ethernet cable
connected, close the NEMA
enclosure and secure the two latches.
Secure the lid in place by reinstalling
the captive screws in the two outer
corners of the lid.
15. Restore machine power by plugging
the unit back in.
South Bend, Indiana USA | networketi.com
QUESTIONS AND COMMENTS
For technical help, questions, or comments
concerning this or any ETI, Inc.,
product, contact the Customer Service
Department between 8:00 a.m. and 5:00
p.m. EST.
DISCLAIMER
ETI, Inc. makes no representations or
warranties, either expressed or implied,
with respect
publication or
describes, and specifically disclaims any
implied warranties of merchantability or
fitness for any particular purpose.
Inc. reserves the right to revise
publication and to make changes and
improvements to the products described
in this publication without the obligation
of ETI, Inc.
organization of such revisions, changes or
improvements.
No part of
reproduced or translated in any form or by
any means, electronic
including photocopying and recording, for
any purpose without the express written
consent of ETI, Inc.
The ETI logo, We Manage Heat, and
ADH are registered
ETI, Inc. NETCOM is a trademark of ETI,
Inc.
Copyright © 2012 ETI, Inc. All rights
reserved.
8
ADH INSTRUCTION MANUAL | PART NO.
to the contents of this
the products that
to notify any person or
this manual may
or mechanical
trademarks
24098
it
ETI,
this
be
of
REV B